Avionics Communication Receivers Online Exam Quiz

Avionics Communication Receivers GK Quiz. Question and Answers related to Avionics Communication Receivers. MCQ (Multiple Choice Questions with answers about Avionics Communication Receivers

What circuit provides the initial selectivity in a receiver?

Options

A : Amplifier

B : Attenuator

C : Multiplexer

D : LC tuned circuits

View Answer

What type of receivers converts all incoming frequency into a lower frequency for better selectivity and sensitivity?

Options

A : Analogous receivers

B : Superheterodyne receivers

C : Digital receiver

D : Crystal receiver

View Answer

The LNA of a transducer has failed during the transmission of a signal. Which component’s failure has caused this?

Options

A : Duplexer

B : RF amplifier

C : Antenna

D : Mixer

View Answer

The ability to pick up week signals by a receiver is called _________

Options

A : Gain

B : Amplification

C : Sensitivity

D : Selectivity

View Answer

What type of oscillators are used to input a wide range of frequencies to the IF amplifier?

Options

A : LC oscillators

B : Crystal oscillators

C : Variable frequency oscillators

D : Diode oscillators

View Answer

What is connected between the antenna and the mixer to avoid oscillator radiation?

Options

A : LNA

B : Attenuator

C : Duplexer

D : Power amplifier

View Answer

Which of the following is not an advantage of using RF amplifiers in the initial stage of signal selection?

Options

A : Low noise

B : Reduced oscillator radiation

C : Better selectivity

D : Less power consumption

View Answer

What is the input signal level that is approximately equal to the average internally generated noise value called?

Options

A : MDS

B : MBS

C : MMD

D : MSD

View Answer

Which of the following are the two main characteristics of receivers?

Options

A : Selectivity and sensitivity

B : Gain and attenuation

C : Modulation and demodulation

D : Multiplexing and demultiplexing

View Answer

Analog signals : Signal to noise ratio:: Digital signals _________

Options

A : Signal Attenuation

B : Bit error rate

C : Error rate

D : Digital noise ratio

View Answer

Chemical Engineering Basics - Part 1 more Online Exam Quiz

Avionics Atmospheric Effects Satellite Signals

Avionics Automatic Landing Systems

Avionics Basic

Avionics Campus Interviews

Avionics Carrier Landing Systems

Avionics Control Data Entry

Avionics Control Laws Fbw

Avionics Data Bus Systems

Avionics Data Conversion 1

Avionics Digital Implementation