Automobile Engineering Basic Online Exam Quiz
Automobile Engineering Basic GK Quiz. Question and Answers related to Automobile Engineering Basic. MCQ (Multiple Choice Questions with answers about Automobile Engineering Basic
The axes of the two shafts are intersecting and are at 35° to each other. These two shafts are connected by Hook’s joint. At which position of the drives shaft velocity ratio will not be unity?
Options
A : 42.145°
B : 222.145°
C : 317.85°
D : 141.52°
The axes of the two shafts are intersecting and are at 35° to each other. These two shafts are connected by Hook’s joint. At which position of the drives shaft acceleration will be maximum?
Options
A : 68.4°
B : 96.1°
C : 225.5°
D : 330.7°
The axes of the two shafts are intersecting and are at 30° to each other. These two shafts are connected by Hook’s joint. At which position of the drives shaft velocity ratio will be minimum?
Options
A : 90°, 270°
B : 0°, 180°
C : 180°, 270°
D : 90°, 180°
The axes of the two shafts are intersecting and are at 25° to each other. These two shafts are connected by Hook’s joint. At which position of the drives shaft velocity ratio will be maximum?
Options
A : 90°, 270°
B : 0°, 180°
C : 180°, 270°
D : 90°, 180°
Where is the differential located?
Options
A : Between transmission and rear axle
B : Between engine and transmission
C : Between two propeller shaft
D : Between steering wheel and steering column
Which of the following is the disadvantage of the open differential?
Options
A : High in cost
B : Not reliable
C : Complex design
D : Sends most of the power to the wheel having less traction
Why do the hypoid gears require special lubricant?
Options
A : Teeth are soft
B : Teeth are hard
C : Gears run faster
D : There is relative motion between teeth
What is the need of the universal joint?
Options
A : To change inclination
B : To bend sideways
C : To transfer torque at an angle
D : To change length
A two-piece propeller shaft requires one universal joint.
Options
A : True
B : False
C :
D :
Which types of joints are used when the shafts are inclined?
Options
A : Universal joint
B : Hinge joint
C : Ball and socket joint
D : Pivot joint
Automobile Engineering 2stroke Engines more Online Exam Quiz
Compilers Transformation From Nfa Dfa 1
Compilers Transformation From Nfa Dfa 2
Automobile Engineering 2stroke Engines
Automobile Engineering Aptitude Test
Automobile Engineering Assessment
Automobile Engineering Braking System
Automobile Engineering Carburettors
Automobile Engineering Charging System