Interfacing to the Analog World - General Questions Online Exam Quiz
Interfacing to the Analog World - General Questions GK Quiz. Question and Answers related to Interfacing to the Analog World - General Questions. MCQ (Multiple Choice Questions with answers about Interfacing to the Analog World - General Questions
If an analog signal is to be converted to an 8-bit resolution, how many comparators are used in a parallel-encoded ADC?
Options
A : 127
B : 128
C : 255
D : 256
A transducer is a device that:
Options
A : converts a physical variable to an electrical variable
B : converts analog data to meaningful data
C : controls a physical variable
D : stores digital data and then processes that data according to a set of specified instructions
How many different voltages can be output from a DAC with a 6-bit resolution?
Options
A : 6
B : 16
C : 32
D : 64
A 4-bit R /2 R D/A converter has a reference of 5 V. What is the analog output for the input code 0101?
Options
A : 3.125 V
B : 0.3125 V
C : 0.78125 V
D : –3.125 V
Which of the following describes the basic operation of a single-slope A/D converter.
Options
A : The input voltage is used to set the frequency of a voltage-controlled oscillator (VCO). The VCO quits changing frequency when the input voltage stabilizes. The frequency of the VCO, which is proportional to the analog input voltage, is measured and is displayed on the digital display as a voltage reading.
B : A ramp generator is used to enable a counter through a comparator. When the ramp voltage equals the input voltage the counter is latched and then reset. The counter reading is proportional to the input voltage since the ramp is changing at a constant V/second rate.
C : A ramp voltage and analog input voltage are applied to a comparator. As the input voltage causes the integrating capacitor to charge, it will at some point equal the ramp voltage. The ramp voltage is measured and displayed on the digital panel meter.
D : Any of the above could be correct, depending on the specific type of A/D converter involved.
The main advantage of the successive-approximation A/D converter over the counter-ramp A/D converter is its:
Options
A : more complex circuitry
B : less complex circuitry
C : longer conversion time
D : shorter conversion time
The quantization error in an analog-to-digital converter can be reduced by:
Options
A : increasing the number of bits in the counter and DAC.
B : decreasing the number of bits in the counter and increasing the number of bits in the DAC.
C : increasing the number of bits in the counter and decreasing the number of bits in the DAC.
D : decreasing the number of bits in the counter and DAC.
One disadvantage of the tracking A/D converter is:
Options
A : that it requires two counters—one for up and one for down.
B : that the binary output will oscillate between two binary states when the analog input is constant.
C : the need for an accurate clock reference for the counter.
D : the need for a latch and its associated control circuit.
If the range of output voltage of a 6-bit DAC is 0 to 15 volts, what is the step voltage of the output?
Options
A : 0.117 volt/step
B : 0.234 volt/step
C : 2.13 volts/step
D : 4.26 volts/step
The process by which a computer acquires digitized analog data is referred to as ________.
Options
A : data acquisition
B : monotonicity
C : analog resolution
D : systematic digital conversion
Boolean Algebra and Logic Simplification - General Questions more Online Exam Quiz
Digital System Projects Using HDL - General Questions
Flip-Flops - General Questions
Integrated-Circuit Logic Families - General Questions
Integrated Circuit Technologies - General Questions
Logic Families and Their Characteristics - General Questions
Logic Gates - General Questions
Memory and Storage - General Questions