Question: A logic probe is placed on the output of a gate and the display indicator is dim. A logic pulser is used on each of the input terminals, but the output indication does not change. What is wrong?
Options
A : The dim indication on the logic probe indicates that the supply voltage is probably low.
B : The output of the gate appears to be open.
C : The LOW indication is the result of a bad ground connection on the logic probe.
D : The gate is a tri-state device.
Testing and Troubleshooting - General Questions more questions
Low power consumption achieved by CMOS circuits is due to....
A TTL totem pole circuit is designed so that the....
The time needed for an output to change as the....
A series of gradually decreasing sine wave oscillations is called:
The determination of a digital signal's frequency and waveshape is....
A +5 V PCB power source that has been "pulled....
Measurement of pulse width should be taken at a 50%....
Which test equipment best allows a comparison between input and....
The duty cycle of a pulse is determined by which....
What is the next step after discovering a faulty gate....
Alternating Current vs Direct Current - General Questions more Online Exam Quiz
Resistance and Power - General Questions
Semiconductor Memory - General Questions
Semiconductor Principles - General Questions
Sequential Logic Circuits - General Questions
Standard Logic Devices (SLD) - General Questions
Thyristors and Tranducers - General Questions
Transistors and Applications - General Questions