Managing a Cisco Internetwork - Managing a Cisco Internetwork Online Exam Quiz
Managing a Cisco Internetwork - Managing a Cisco Internetwork GK Quiz. Question and Answers related to Managing a Cisco Internetwork - Managing a Cisco Internetwork. MCQ (Multiple Choice Questions with answers about Managing a Cisco Internetwork - Managing a Cisco Internetwork
You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful?
Options
A : 1, 3 and 4
B : 2, 4 and 5
C : 3 and 5 only
D : 5 only
What information is displayed by the show hosts command?
Options
A : 1, 2 and 3
B : 1 and 4
C : 3, 4, and 5
D : All of the above
You are unsuccessful in telnetting into a remote device. What could the problem be?
Options
A : 1 only
B : 3 only
C : 2 and 4 only
D : All of the above
Which three commands can be used to check LAN connectivity problems on a router?
Options
A : 1 ,2 and 4
B : 2 and 5
C : 3 and 5
D : None of the above
If you want to have more than one Telnet session open at the same time, what keystroke combination would you use?
Options
A : Tab+Spacebar
B : Ctrl+X, then 6
C : Ctrl+Shift+X, then 6
D : Ctrl+Shift+6, then X
Which command will copy the IOS to a backup host on your network?
Options
A : transfer IOS to 172.16.10.1
B : copy run start
C : copy start tftp
D : copy flash tftp
Which command loads a new version of the Cisco IOS into a router?
Options
A : copy flash ftp
B : copy ftp flash
C : copy flash tftp
D : copy tftp flash
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
Options
A : Router> ping
B : Router> trace
C : Router> show ip route
D : Router> show interface
The configuration register setting of 0x2102 provides what function to a router?
Options
A : Tells the router to boot into ROM monitor mode
B : Provides password recovery
C : Tells the router to look in NVRAM for the boot sequence
D : Boots the IOS from a TFTP server
You telnet to a router and make your necessary changes; now you want to end the Telnet session. What command do you type in?
Options
A : close
B : disable
C : disconnect
D : exit
EIGRP and OSPF - EIGRP and OSPF more Online Exam Quiz
EIGRP and OSPF - EIGRP and OSPF
Internetworking - Internetworking
IOS and Security Device Manager - IOS and Security Device Manager
Network Address Translation - Network Address Translation
Networking Basics - Networking Basics