Radio Receivers - Part 1 Online Exam Quiz

Radio Receivers - Part 1 GK Quiz. Question and Answers related to Radio Receivers - Part 1. MCQ (Multiple Choice Questions with answers about Radio Receivers - Part 1

The noise generated by a resistor depends upon

Options

A : its resistance value

B : its operating temperature

C : both its resistance value and operating temperature

D : none of the above

View Answer

In a superheterodyne receiver

Options

A : the IF stage has better selectivity than RF stage

B : the RF stage has better selectivity than IF stage

C : the RF stage has same selectivity than IF stage

D : none of the above

View Answer

The function of an AM detector circuit is to

Options

A : rectify the input signal

B : discard the carrier

C : provide audio signal

D : all of the above

View Answer

Which of the following should be used in order to prevent overloading or the last IF amplifier in a receiver?

Options

A : Variable selectivity

B : Variable sensitivity

C : Double conversion

D : Squelch

View Answer

Most popular IF for receivers tuning to 540 to 1650 kHz is

Options

A : 433 kHz

B : 455 kHz

C : 545 kHz

D : 555 kHz

View Answer

In a broadcast superheterodyne receiver

Options

A : the local oscillator operates below the signal frequency

B : local oscillator frequency is normally double the IF

C : RF amplifier normally works at kHz above the carrier frequency

D : mixer input must be tuned to the signal frequency

View Answer

A duplexer is a device used to

Options

A : feed more than one receiver from a single antenna

B : connect two transmitters to the same antenna

C : connect a receiver and a transmitter to the same antenna

D : none of these

View Answer

A heterodyne frequency changer is called a

Options

A : Modulator

B : Mixer

C : Demodulator

D : Frequency translator

View Answer

RF amplifiers are used in radio receivers for

Options

A : improved image frequency rejection

B : improved rejection of adjacent unwanted signals

C : prevention of re-radiation of the local oscillator through the antenna of the receiver

D : all of the above

View Answer

The sensitivity curve of a standard receiver is represented by

Options

A : curve A

B : curve B

C : curve C

D : curve D

View Answer

Analog Electronics - Part 1 more Online Exam Quiz

Measurements and Instrumentation - Part 1

Microprocessors - Part 1

Microwave Communication - Part 1

Networks Analysis and Synthesis - Part 1

Power Electronics - Part 1

Satellite Communication - Part 1

Signals and Systems - Part 1

General Principles - General Questions

Declarations and Access Control - General Questions