Transistor Bias Circuits - General Questions Online Exam Quiz

Transistor Bias Circuits - General Questions GK Quiz. Question and Answers related to Transistor Bias Circuits - General Questions. MCQ (Multiple Choice Questions with answers about Transistor Bias Circuits - General Questions

Clipping is the result of

Options

A : the input signal being too large.

B : the transistor being driven into saturation.

C : the transistor being driven into cutoff.

D : all of the above

View Answer

Which transistor bias circuit arrangement provides good stability using negative feedback from collector to base?

Options

A : base bias

B : collector-feedback bias

C : voltage-divider bias

D : emitter bias

View Answer

Refer to the given figure. The most probable cause of trouble, if any, from these voltage measurements is

Options

A : the base-emitter junction is open.

B : R E is open.

C : a short from collector to emitter.

D : no problems.

View Answer

Refer to the given figure. The most probable cause of trouble, if any, from these voltage measurements is

Options

A : the base-emitter junction is open.

B : R E is open.

C : a short from collector to emitter.

D : no problems.

View Answer

What is the dc input resistance at the base of a BJT?

Options

A : DC R C

B : DC ·( )

C : DC ·r e ?

D : DC R E

View Answer

Which transistor bias circuit provides good Q-point stability with a single-polarity supply voltage?

Options

A : base bias

B : collector-feedback bias

C : voltage-divider bias

D : emitter bias

View Answer

Refer to this figure. In the voltage-divider biased npn transistor circuit, if R 2 opens, the transistor is

Options

A : saturated.

B : cutoff.

C : nonconducting.

D : -

View Answer

Ideally, for linear operation, a transistor should be biased so that the Q-point is

Options

A : near saturation.

B : near cutoff.

C : where I C is maximum.

D : halfway between cutoff and saturation.

View Answer

The most stable biasing technique used is the

Options

A : voltage-divider bias.

B : base bias.

C : emitter bias.

D : collector bias.

View Answer

Refer to this figure. The value of I B is

Options

A : 53 A.

B : 50 A.

C : 50 mA.

D : 53 mA.

View Answer

Active Filters - General Questions more Online Exam Quiz

Semiconductor Diodes - General Questions

Semiconductors - General Questions

Special-Purpose Diodes - General Questions

Special-Purpose Op-Amp Circuits - General Questions

Thyristors - General Questions

Two-Terminal Devices - General Questions

Voltage Regulators - General Questions

Alternating Current vs Direct Current - General Questions

Analog and Digital Converters - General Questions