GATE Exam Questions - Part 1 Online Exam Quiz
GATE Exam Questions - Part 1 GK Quiz. Question and Answers related to GATE Exam Questions - Part 1. MCQ (Multiple Choice Questions with answers about GATE Exam Questions - Part 1
The number of simultaneous equations to be solved in the slope deflection method, is equal to :
Options
A : the degree of statical indeterminacy
B : the degree of kinematic indeterminacy
C : the number of joints in the structure
D : none of the above
Maximum size of a fillet weld for a plate of square edge is
Options
A : 1.5 mm less than the thickness of the plate
B : one half of the thickness of the plate
C : thickness of the plate itself
D : 1.5 mm more than the thickness of the plate
The treatment that should be given to the water from a deep tube well is :
Options
A : pre-settling only
B : coagulation and flocculation only
C : filtration only
D : disinfection only
On sag (or valley) curves the available sight distance is determined based on :
Options
A : design speed
B : height of obstacle
C : height of driver eye
D : night-time driving conditions
In a steady radial flow into an intake, the velocity is found to vary as (1/ r 2 ), where r is the radial distance. The acceleration of the flow is proportional to
Options
A : 1/ r 5
B : 1/ r 3
C : 1/ r 4
D : 1/ r
The wall shown in the below figure has failed. The cause of failure or the error made in the design of the failded wall is :
Options
A : deep slip surface failure
B : overturning
C : no proper drainage in the clay backfill
D : translational failure
The span to depth ratio limit is specified in IS : 456-1978 for the reinforced concrete beams, in order to ensure that the
Options
A : tensile crack width is below a limit
B : shear failure is avoided
C : stress in the tension reinforcement is less than the allowable value
D : deflection of the beam is below a limiting value
Some of the structural strength of a clayey material that is lost by remoulding is slowly recovered with time. This property of soils to undergo an isothermal gel-to-soil-to-gel transformation upon agitation and subsequent rest is termed :
Options
A : Isotropy
B : Anisotropy
C : Thixotropy
D : Allotropy
The capacities of "One-way 1.5 m wide sidewalk (persons per hour)" and "One-way 2-lane urban road (PCU per hour, with no frontage access, no standing vehicles and very little cross traffic)" are respectively.
Options
A : 1200 and 2400
B : 1800 and 2000
C : 1200 and 1500
D : 2000 and 1200
Is 459-1978 recommends to provide certain minimum steel in a RCC beam
Options
A : to ensure compression failure
B : to avoid rupture of steel in case a flexural failure occurs
C : to hold the stirrup steel in position
D : to provide enough ductility to the beam
Advanced Surveying - Part 1 more Online Exam Quiz
Construction Management - Part 1
Elements of Remote Sensing - Part 1