Configuration Layout - Wing/Tail Layout and Loft-1 Online Exam Quiz
Configuration Layout - Wing/Tail Layout and Loft-1 GK Quiz. Question and Answers related to Configuration Layout - Wing/Tail Layout and Loft-1. MCQ (Multiple Choice Questions with answers about Configuration Layout - Wing/Tail Layout and Loft-1
A constant percent chord line is drawn from root airfoil to tip airfoil in linear interpolation method.
Options
A : TRUE
B : FALSE
C : -
D : -
Determine the corrections or otherwise of the following assertion [A] and reason [R]:^ Assertion [A]: Typically control surface are tapered with same taper ratio as primary component such as wing or tail^ Reason[R]: Control surface is used to provide trim control to the A/C
Options
A : Both [A] and [R] are true and [R] is the correct reason for [A]
B : Both [A] and [R] are true but [R] is not the correct reason for [A]
C : Both [A] and [R] are false
D : [A] is false but [R] is true
For wing to be lofted as shown in below figure, what will be the approximated value of MAC?^
Options
A : 8m from l.e.
B : 8m from t.e.
C : 12m from l.e.
D : 12m from t.e.
From following diagram find the value of MAC of wing.^
Options
A : 5.8m
B : 6.8m
C : 2.5m
D : 10m
High speed aircraft is affected by __
Options
A : aileron reversal
B : flap inversion
C : drafting
D : independent from any disturbances
If a wing has span of 12m. Find the approximated length of the aileron of starboard wing.
Options
A : 2.4m
B : 20m
C : 15m
D : 25m
If wing has MAC of 8m then, what will be the location of aerodynamic centre?
Options
A : 2m from l.e.
B : 2m from t.e.
C : At l.e.
D : At t.e.
In linear interpolation method, new airfoil is created as __
Options
A : weighted average of root and tip airfoil
B : heavier than the root airfoil always
C : higher chord than root always
D : lower chord than tip always
Let's consider flat wrapping is to be used for lofting. If wing has taper ratio of 0.4, span of 26.6ft and root chord Cr is 76in then, find the area to be covered by flat wrapping.
Options
A : 118ft2
B : 200ft2
C : 1600in
D : 10m
Rolling tails can be used by high speed A/C.
Options
A : TRUE
B : FALSE
C : -
D : -
Aerodynamic Coefficients more Online Exam Quiz
Configuration Layout - Maintainability Considerations
Configuration Layout - Producibility Considerations
Configuration Layout - Structural Considerations
Configuration Layout - Vulnerability Considerations
Configuration Layout - Wetted Area and Volume Determination
Configuration Layout - Wing/Tail Layout and Loft-2
Configuration Layout Considerations - Aural Signature
Configuration Layout Considerations - Infrared Detectability