Water Jet Machining - Introduction and Machining system Online Exam Quiz
Water Jet Machining - Introduction and Machining system GK Quiz. Question and Answers related to Water Jet Machining - Introduction and Machining system. MCQ (Multiple Choice Questions with answers about Water Jet Machining - Introduction and Machining system
How many parts are cut using Water jet machining, on a single blank?
Options
A : One part
B : Two parts
C : Three parts
D : Multiple parts
In how many directions, can the cutting takes place in Water jet machining?
Options
A : Uni-directional
B : Bi-directional
C : Multi-directional
D : None of the mentioned
In Water jet machining, cuts can be started at which place of workpiece?
Options
A : From left
B : From right
C : From middle
D : From any point
In Water jet machining, tool need not require sharpening once the machining is done.
Options
A : TRUE
B : FALSE
C : -
D : -
Intensifier increases the pressure water by which of the following values?
Options
A : 10 ? 100 MPa
B : 100 ? 200 MPa
C : 200 ? 400 MPa
D : 400 ? 1000 MPa
On which property of water, will the accumulator in Water jet machining rely on?
Options
A : Density
B : Compressibility
C : Viscosity
D : Velocity
State whether the following statement is true or false.^ ?To start the cuts in Water jet machining, pre-drilled holes are not necessary.?
Options
A : TRUE
B : FALSE
C : -
D : -
What are the uses of catcher in machining system of Water jet machining?
Options
A : Collecting dirt
B : Collection of debris
C : Reduce noise levels
D : All of the mentioned
What are the values of typical tube diameters in the machining system in WJM?
Options
A : 0.1 to 1 mm
B : 1 to 6 mm
C : 6 to 14 mm
D : 14 to 25 mm
What is the expected life of the nozzles used in WJM?
Options
A : 10 hrs
B : 20 hrs
C : 100 hrs
D : 200 hrs
Abrasive Jet Machining - Introduction and Machining system more Online Exam Quiz
USM - Dimensional Accuracy and Surface Quality
WJM - Advantages and Disadvantages