Question: The dimensions which are smaller are to be placed _______
Options
A : Nearer to the view
B : Further from the outline of the view
C : Inside the view
D : On the view
Engineering Drawing Aptitude Test more questions
Electronic transitions corresponds to ___________ region.
Ideally, for non linear operation, a transistor should be biased....
____ is characterized by software communication architecture compliance.
Which among the following is a prototype for mobile ad-hoc....
Where is blower installed in induced draught system?
In a reduced bearing system, bearing is measured from:
Which among the following is the correct definition of nearest....
What causes the pre-selected volume of air to flow into....
Which of the following processes is known for pouring of....
Which of the following is not a common symptom of....
Chemical Engineering Basics - Part 1 more Online Exam Quiz
Engineering Chemistry Uses Limitations Phase Rule
Engineering Chemistry Valence Bond Theory
Engineering Chemistry Viscosity
Engineering Chemistry Wet Theory Corrosion
Engineering Chemistry Written Test
Engineering Drawing Assessment
Engineering Drawing Basic Principles Dimensioning 1