Question: During Chemical milling, depth of etch is controlled by which factor of immersion?
Options
A : Time
B : Mask method
C : Mask area
D : None of the mentioned
Chemical Milling - Introduction more questions
What is the value of orifice diameter in Abrasive water....
What is the value of stand-off distance in Abrasive water....
When compared to sand, how much effective is garnet as....
By using Chemical machining, which of the following can be....
CHM cannot eliminate which of the following defects?
In Chemical milling, excessive flow of chemical reagent results in....
Of the following, which ratio defines the etch factor?
Pre cleaning is done on the work piece surface in....
Special coatings applied on work piece materials in order to....
State whether the following statement about Chemical milling is true....
Abrasive Jet Machining - Introduction and Machining system more Online Exam Quiz
Abrasive Water Jet Machining - Introduction
AJM - Applications, Advantages and limitations
AJM - Material Removal Rate and Process parameters